Buell 2005 P3 Service Manual page 209

HOME
ASSEMBLY
1. Wash cylinder head and valves in warm, soapy water to
remove all debris.
2. Scrub valve guide bores with VALVE GUIDE BRUSH
(Part No. HD-34751) and hot, soapy water.
11 1
WARNING
Compressed air can pierce the skin and flying debris
from compressed air could cause serious eye injury.
Wear safety glasses when working with compressed air.
Never use your hand to check for air leaks or to deter-
mine air flow rates. (00061a)
3. Blow dry with compressed air.
4. Apply a liberal amount of engine oil to the valve stem.
5. Insert valve into valve guide and install lower collar.
6610
Figure 3-62. Valve Guide Seal Protector Sleeve
6. See Figure 3-62. Place a protective sleeve over the valve
stem keeper groove. Coat the sleeve with oil and place a
new seal over the valve stem.
CAUTION
Always use a protective sleeve on the valve stem keeper
groove when installing valve stem seal. If the seal is
installed without using the protective sleeve, the seal will
be damaged.
CAUTION
Do not remove valve after seal is installed. Otherwise,
sharp edges on keeper groove will damage seal.
WARNING
a0088x3x
5
1. Driver handle
2. Valve seat installation tool
3. Valve stem seal
4. Lower collar
5. Valve guide
Figure 3-63. Valve Seal Installation
7. See Figure 3-63. Tap the valve stem seal onto the valve
guide using the VALVE SEAL INSTALLATION TOOL
(Part No. HD-34643A) and DRIVER HANDLE (Part No.
HD-34740). The seal is completely installed when the
tool touches the lower collar.
8. See Figure 3-49. Install valve springs and upper collar.
9. Compress springs with VALVE SPRING COMPRESSOR
(Part No. HD-34736B).
10. Insert valve keepers into upper collar, making sure they
engage groove in valve stem. The keeper gaps should be
equal.
11. Release and remove VALVE SPRING COMPRESSOR.
12. Repeat Steps 4-11 for the remaining valve.
1
2
3
4
2005 Buell P3: Engine 3-35