Buell 2005 P3 Service Manual page 128

HOME
INSTALLATION
1. Fit front brake caliper on rotor.
a. Slide carrier on caliper.
b. Slide caliper over front brake rotor without brake
pads installed.
8273
1
2
3
4
5
1. Brake line
2. Bleeder valve
3. Banjo bolt (metric)
4. Banjo washers (2)
5. Pin plug
6. Mounting screws (2)
7. Wireform
Figure 2-41. Front Brake Caliper
2. See Figure 2-41. Apply LOCTITE 272 (red) to both cali-
per mounting screws (6). Install wireform to upper screw
and tighten both screws to 18-22 ft-lbs (24-30 Nm).
7
6
7702
2
1
1. Pad hanger pin (metric)
2. Pad spring
Figure 2-42. Pad Spring
3. See Figure 2-42. Install brake pads.
a. Install pad spring (2) with opening at top as shown.
b. Insert inboard brake pad from rear of caliper.
c. Insert outboard pad.
d. See Figure 2-42. Install pad hanger pin (1) (metric).
Tighten to 132-180 in-lbs (15-20 Nm).
e. See Figure 2-41. Install pin plug (5). Tighten to 18-
25 in-lbs (2-3 Nm).
11 1
WARNING
Use only new black banjo washers (See Parts Catalog for
Part No.) with D.O.T. 4 brake fluid. Earlier silver banjo
washers are not compatible with D.O.T. 4 fluid and will
not seal properly over time. Failure to comply may
adversely affect braking ability and lead to brake failure
which could result in death or serious injury.
CAUTION
To avoid leakage, verify that banjo washers, banjo bolt,
hydraulic brake line and caliper bore are completely
clean.
4. See Figure 2-41. Connect brake line (1) to caliper using
two new banjo washers (4) and banjo bolt (3) (metric).
Tighten to 16-20 ft-lbs (22-27 Nm).
5. Route brake line through wireform.
WARNING
2005 Buell P3: Chassis 2-29