Installing The Seat; Installing The Seat Belt; Installing The Manual Tube - Toro 30344 Operator's Manual

3

Installing the Seat

Parts needed for this procedure:
1 Seat—Model No. 30398 (optional kit)
Mechanical seat suspension kit—Model No. 30312
1 (optional kit) or Pneumatic seat suspension kit—Model
No. 30313 (optional kit)
Procedure
The Groundsmaster 3280-D is shipped without the seat
assembly. Obtain and install the optional seat (Model 30398)
and the Mechanical Seat Suspension Kit (Model 30312) or the
Pneumatic Seat Suspension Kit (Model 30313). Refer to the
seat kit for the installation instructions.
Note: Obtain and install the Auxiliary Power Unit Kit
(Model 30382) before installing a Pneumatic Suspension Seat
Kit to the machine.
Note: Refer to
5 Installing the Manual Tube (page 13)
mounting the seat to the seat suspension.
4

Installing the Seat Belt

Parts needed for this procedure:
1 Seat belt
2 Bolts (7/16 x 1 inch
2 Lock washer (7/16 inch
2 Flat washer (7/16 inch
Procedure
Important: Mount the latch side of the belt to the right
side of the seat.
1. Seat-belt latch
1. Assemble end of each seat belt halves to the holes in
the back of the seat with 2 bolts (7/16 x 1 inch), flat
washers (7/16 inch), and lock washers (7/16 inch)
(Figure 6).
2. Torque the bolts to 61 to 75 N∙m (45 to 55 ft-lb).
5
before

Installing the Manual Tube

Parts needed for this procedure:
1 Manual tube
2 R-clamp
Procedure
1. Remove the manual tube and R-clamps secured to the
seat plate.
Note: Discard the 2 mounting bolts and flat washers.
2. Remove the 2 nuts and vinyl caps (if previously
installed) securing the upper seat bracket to the left side
of the seat suspension
3. Loosely mount the R-clamps to the seat bracket studs
with the 2 nuts previously removed
Note: Position the R-clamps under the seat-suspension
tabs.
13
Figure 6
(Figure 7).
(Figure 7).