Hydraulic Pump Access - Toro 30344 Operator's Manual

Hydraulic Pump Access

Removing the Seat and Seat Plate
1. Remove the 2 flange-head bolts (3/8 x 3/4 inch) at the
that secure the front of the seat plate to the chassis of
the machine (Figure
1. Flange locknuts (3/8 inch)
2. Flange-head bolts (3/8 x
3/4 inch)
3. Seat plate
2. Remove the 2 flange locknuts (3/8 inch) at the that
secure the back of the seat plate to the chassis of the
machine (Figure 38)
3. Partially lift the seat assembly.
4. Disconnect the 2-pin connector for the
operator-presence switch harness from the
2-socket connector of the wire harness for the machine
(Figure 38).
5. Remove the seat assemble from the machine.
Installing the Seat and Seat Plate
Install the seat once you have repaired the machine and closed
the bypass valve for the hydraulic pump.
1. Align the seat assemble to the opening in the fuel tank.
2. Connect the 2-pin connector for the operator-presence
switch harness into the 2-socket connector of the
wire harness for the machine; refer to
Removing the Seat and Seat Plate (page
3. Align the rear holes in the seat plate
Removing the Seat and Seat Plate (page
carriage bolts (3/8 x 1 inch) in the radiator channel.
38).
Figure 38
4. 2-socket connector (wire
harness for the machine
5. 2-pin connector
(operator-presence switch
harness)
Figure 38
37).
(Figure 38
37)) with the 2
4. Assemble the seat plate
with the 2 flange locknuts (3/8 inch) that you removed
in step 2
5. Align the front holes in the seat plate
the threads of the tank rods.
6. Assemble the seat plate
with the 2 flange-head bolts (3/8 x 3/4 inch) that you
removed in step
(page 37).
7. Torque the flange locknuts and flange-head bolts to 37
to 45 N∙m (27 to 33 ft-lb).
8. Checking the interlock system; refer to
Interlock System (page
of
of
37
(Figure 38) to the carriage bolts
of Removing the Seat and Seat Plate (page
(Figure 38) to the tank rods
1 of Removing the Seat and Seat Plate
27).
37).
(Figure 38) with
Checking the