Installing The Seat Assembly - Toro TimeCutter SW Series Setup Instructions

4

Installing the Seat Assembly

Parts needed for this procedure:
1
Seat assembly
1 Seat rod
2 Hairpin cotter pins
2 Spacers (certain models only)
Procedure
1. Install the seat assembly to the frame with the seat rod,
2 hairpin cotter pins, and 2 spacers (certain models
only) as shown in Figure
Figure 6
1. Seat assembly
2. Spacers
6.
g027723
3. Hairpin cotter
4. Seat rod with hairpin cotter
installed
2. Connect the seat switch
3. Route the wire harness to the right side of the machine
and push the plastic connector into the seat frame hole
(Figure 8).
1. Plastic connector in seat
frame hole
4
(Figure 7).
g027695
Figure 7
1 2
Figure 8
2. Wire harness
RELEASED Ver-C ©Toro 2016
g027695
g028383
g028383