Toro 30344 Operator's Manual page 58

Figure 81
1. Front of the machine
C. Move the traction pedal to the full forward
position (Figure
D. While holding the traction-pedal stop, adjust the
jam nut that is above the foot-rest plate
80) until the traction pedal makes contact with
the stop.
E. Lengthen the traction-pedal stop position by
rotating the stop 1 full rotation counterclockwise
away from the jam nut above the foot-rest plate.
Note: Shortening he traction-pedal stop position
will increase the forward speed of the machine.
F. While holding the traction-pedal stop, torque
the jam nut at the bottom of the foot-rest plate
(Figure 80 and Figure
33 ft-lb).
G. Check that the traction pedal contacts the
traction-pedal stop before the pump reaches full
stroke.
Note: If the traction pedal does not contact the
traction-pedal stop, repeat steps
refer to Adjusting the Traction Rod (page
2. Jam nut (bottom of the
foot-rest plate)
80).
(Figure
81) to 37 to 45 N∙m (27 to
A through
58).
Adjusting the Traction Rod
If more adjustment is required, adjust the traction rod
82) as follows:
1. Remove the bolt and nut securing traction rod end to
the pedal.
2. Loosen the jam nut securing rod end to the traction
rod (Figure
3. Rotate the rod until you achieve the desired length.
4. Tighten the jam nut
to the traction pedal with the bolt and nut removed to
lock the angle of the foot pedal.
1. Rod end
2. Jam nut
G or
58
82).
(Figure 82) and secure the rod end
Figure 82
3. Traction rod
(Figure