Specifications; Attachments/Accessories; Before Operation; Before Operation Safety - Toro 30344 Operator's Manual

Charge Indicator
The charge indicator illuminates if electrical charging system is
operating above or below the normal operating range
22). Check and/or repair the electrical charging system.
Oil-Pressure-Warning Light
The oil-pressure-warning light
pressure in engine drops below a safe-operating level. If the
oil-pressure-warning light ever illuminates, shut off the engine
and determine the cause of the low oil pressure condition.
Repair the engine-oil system before starting the engine again.
Lift-Lock Lever
Use the lift-lock lever to secure the lift switch
the - position, when performing maintenance on
RAISE DECK
the deck or when transporting between mowing locations.

Specifications

Note: Specifications and design are subject to change
without notice.
Length
Width (Rear wheels)
Height without ROPS
Height with ROPS
Net Weight (Model 30344)
Net Weight (Model 30345)

Attachments/Accessories

A selection of Toro approved attachments and accessories is
available for use with the machine to enhance and expand
its capabilities. Contact your Authorized Service Dealer or
Distributor or go to www.Toro.com for a list of all approved
attachments and accessories.
(Figure
(Figure 22) illuminates if the oil
(Figure 22), to
208 cm (82 inches)
119 cm (47 inches)
127 cm (50 inches)
196 cm (77 inches)
635 kg (1,400 lb)
794 kg (1,751 lb)
Operation

Before Operation

Before Operation Safety

CAUTION
This machine produces sound levels in excess of 85
dBA at the operators ear and can cause hearing loss
through extended periods of exposure.
Wear hearing protection when operating this
machine.
CAUTION
If the machine does not have adequate rear weight,
the rear wheels may come off the ground, causing
you to lose control of the machine.
• Add the necessary amount of rear weight to
prevent the rear wheels from leaving the ground.
• Do not stop suddenly while you raise the deck
or implement.
• Do not travel downhill with the deck or
implement raised.
Important: Refer to the 2 weight tables in
the Rear Weights (page 19)
regarding additional weight required for your machine.
General Safety
•
Never allow children or untrained people to operate or
service the machine. Local regulations may restrict the
age of the operator. The owner is responsible for training
all operators and mechanics.
•
Become familiar with the safe operation of the equipment,
operator controls, and safety signs. Know how to stop
the machine and engine quickly.
•
Check that all safety devices are attached and
functioning properly. This includes, but is not limited to,
operator-presence controls; safety switches and shields;
the rollover protection system (ROPS); attachments; and
brakes. Do not operate the machine unless all safety
devices are in position and functioning as intended by
the manufacturer.
•
Always inspect the machine to ensure that the blades,
blade bolts, and cutting assembly are not worn or
damaged. Replace worn or damaged blades and bolts in
sets to preserve balance.
24
.12 Installing
for more information