Lubrication; Greasing The Bearings And Bushings - Toro 30344 Operator's Manual

Lubrication

Greasing the Bearings and
Bushings
Service Interval: Every 50 hours—Grease the bearings and
bushings. When operating the machine
in extremely dusty and dirty conditions,
lubricate the bearings and bushings daily.
Every 400 hours/Yearly (whichever comes
first)—Grease the rear-axle bearings
Grease specification: No. 2 lithium grease.
Important: Dusty and dirty operating conditions
could cause dirt to get into the bearings and bushings,
resulting in accelerated wear.
Note: Lubricate grease fitting immediately after every
washing, regardless of interval specified.
1. Wipe grease fitting clean so foreign matter cannot be
forced into the bearing or bushing.
2. Pump grease into the bearing or bushing.
3. Wipe up excess grease.
The bearing and bushing lubrication points are as follows:
•
PTO universal shaft (Figure
Figure 39
•
Lift-arm pivot bushings
39)
(Figure 40)
•
Brake pivot bushings
•
Brake cables (drive wheel and brake pedal ends)
41)
•
PTO tension pivot
•
Rear PTO bearing
•
Rear wheel spindle bushings
38
Figure 40
(Figure 41)
Figure 41
(Figure 42)
Figure 42
(Figure 42)
(Figure 43)
(Figure