Toro 30344 Operator's Manual page 48

Figure 62
1. Check plug
Figure 63
1. Fill/check plug (outboard-axle case—1 on each end of axle)
3. Check that there is lubricant up to the threads at the
bottom of each plug hole
4. .If the level of lubricant is low, perform the following:
and
A. If filling the center-axle housing, remove the fill
plug (Figure 62).
B. Add the specified rear-axle lubricant into the axle
reservoir(s) until the lubricant level up to the
bottom of the check-plug holes
Figure 63).
C. If removed from the center-axle housing, apply
PTFE thread sealant to the threads of the fill plug
and install it into the housing
5. Apply PTFE thread sealant to the threads of the check
plug from the center-axle housing and fill/check plugs
from the 2 outboard-axle cases
6. Install the check plug into the center-axle housing and
fill/check plugs into the 2 outboard-axle cases
62 and Figure 63).
2. Fill plug
(Figure 62 and Figure 63).
(Figure 62 and
(Figure 62).
(Figure 62).
(Figure
Changing the Rear Axle Lubricant
(Model 30345 Only)
Service Interval: Every 400 hours
1. Position the machine on a level surface.
2. Clean the areas around the 3 drain plugs
Note: 1 plug at each outboard-axle case and 1 plug
at the center-axle housing.
1. Drain plug (3)
3. Align a drain pan under the drain plug, remove the
plug, and allow the oil to completely drain.
4. Apply PTFE thread sealant to the threads of the
drain-plug and install it in the axle.
5. Repeat steps .3 and
6. Remove the check plug from the center-axle housing
and the fill/check plugs at each outboard-axle case
7. Add the specified rear-axle lubricant into the axle
reservoir(s) until the lubricant level up to the bottom of
the threads at check-plug hole; refer to the lubrication
specification in
30345 Only) (page
8. Apply PTFE thread sealant to the threads of the check
plug from the center-axle housing and fill/check plugs
from the 2 outboard-axle cases; refer to
Figure 63 in Checking the Rear Axle Lubricant (Model
30345 Only) (page
9. Install the check plug into the center-axle housing and
fill/check plugs into the 2 outboard-axle cases; refer
to Figure 62 and
Lubricant (Model 30345 Only) (page
48
(Figure
Figure 64
4 at the other 2 drain plugs.
Maintaining the Rear Axle (Model
47).
Figure 62
47).
Figure 63 in Checking the Rear Axle
47).
64).
and