Read Mode Settings - Opticon RS232 User Manual

Manual No. 25-ULGPMU01-01

Read Mode Settings

Single Read - When a bar code has been decoded, the reader will be turned OFF. The reader must be triggered again to read
another label. This option and "Disable trigger" cannot be programmed at the same time.
Multiple Read - When a bar code has been decoded, the reader will stay ON for a time as set by "read time settings" or
indefinitely if the trigger switch has been disabled. The same label can only be decoded again after the label has not been detected
for a number of scans.
Continuous Read - The reader will produce as much data as it can decode regardless whether it is the same or not. This mode is
mainly used for demonstration and diagnosis.
Add-on Wait Mode - Used if UPC/EAN with add-on is enabled. The reader searches within the selected time for a valid add-on
code. If a valid add-on code is found, the reader transmits the data immediately. If nothing is found behind the code, the scanner
will transmit the data without add-on. If something is found behind the code, the reader ignored the code in case it is not a valid
add-on.
Start/End
Program
ZZ
Menu
Single
S0
read
Multiple
S1
read
Continuous
S2
read
Add-on
XA
wait mode
disabled
Add-on
XB
wait mode
0.25 sec.
Add-on
XC
wait mode
0.50 sec.
Add-on
XD
wait mode
0.70 sec.
Series LGP Handheld CCD Scanner
[[
T1
T2
T3
YB
TC
YD
YE
Page 53