In The Event Of Problems - Beurer BGL40 Instructions For Use Manual

10 I
N THE EVENT OF PROBLEMS
Messages on the display concerning batteries and blood glucose testing
No.
Cause
E-b Low batteries
E-t Temperature of
environment, monitor or
test strip outside approved
range
E-U Used or contaminated test
strip was inserted
Messages on the display concerning blood pressure testing
No. Cause
Err 01 Cuff leaks or pressure too
low
Err 02 Systolic pressure cannot
be measured
Err 03 Cuff pressure is too high
(greater than 300 mmHg)
Err 04 Diastolic pressure cannot
be measured
Err 07 Systolic pressure out of
range
Beurer BGL40 mg/dL
Remedy
Replace all batteries.
Repeat test with new test strip once
environment, monitor and test strip are
at room temperature (+20 to +25°C).
• Insert an unused and unexpired test
strip
• Repeat blood glucose test
Remedy
Position the cuff correctly (see "5.1
Positioning the cuff", page 21) and
repeat the test
Repeat test and do not move or talk
during the test.
Do not crimp the cuff.
Repeat test and do not move or talk
during the test.
Repeat test and do not move or talk
during the test.
41