Avaya 1000 Series Configuration Manual page 261

Note:
Cables types RS-232, RS-449, EIA-530, EIA-530A and v35 are also supported. If
cable_type is configured for RS-232 the clock rate will be limited to 115200 Hz.
Note:
Saving the configuration and rebooting is recommended after any serial port changes.
Example
Configuring the Secure Router at Site A
Select a cable type for each port.
SR/configure> module serial 1
SR/configure/module/serial 1> cable_type x21
SR/configure/module/serial 1 > exit
SR> save local
Create the bundle.
SR/configure > interface bundle MLPPP-A
Configuring a new WAN bundle interface MLPPP-A.
Begin by adding WAN link(s) to this bundle and selecting encapsulation.
SR/configure/interface/bundle MLPPP-A > link serial 1
SR/configure/interface/bundle MLPPP-A > link serial 2
SR/configure/interface/bundle MLPPP-A > encapsulation ppp
SR/configure/interface/bundle MLPPP-A > ip address 192.168.100.100
24
SR/configure/interface/bundle MLPPP-A > exit
SR> save local
SR > show interface bundles
Note:
Bundle link provisioning is dependant on "clock_rate", "crc", and "data_inversion" settings.
Bundles must be provisioned again if any of these settings changes.
Example
Configuring the Secure Router at Site B
Select the cable type and mode for each port.
SR/configure > module serial 1
SR/configure/module/serial 1 > cable_type x21
SR/configure/module/serial 1 > mode dce
SR/configure/module/serial 1 > exit
SR/configure > module serial 2
SR/configure/module/serial 2 > cable_type x21
SR/configure/module/serial 2 > mode dce
SR/configure/module/serial 2 > exit
SR> save local
Create the bundle.
SR/configure > interface bundle MLPPP-B
Configure a new WAN bundle interface MLPPP-B.
Begin by adding WAN link(s) to this bundle and selecting encapsulation.
SR/configure/interface/bundle MLPPP-B > link serial 1
SR/configure/interface/bundle MLPPP-B > link serial 2
SR/configure/interface/bundle MLPPP-B > encapsulation ppp
SR/configure/interface/bundle MLPPP-B > ip address 192.168.100.101
24
SR> save local
SR/configure/interface/bundle MLPPP-B > exit
Avaya Secure Router 1000 Series Configuration Guide
Serial Configuration
December 2010 261