Avaya 1000 Series Configuration Manual page 24

Secure Router Basics
server by domain name, note that DNS entries need to be configured before SNTP will function
properly.
Configuring multiple SNTP servers
Use the following procedure to configure multiple SNTP servers.
Procedure steps
1. To configure multiple SNTP servers, enter Configuration Mode.
2. Since DNS entries must be configured for SNTP to function properly, configure
3. To configure an SNTP server, enter the sntp sub-tree.
4. Configure the source address of the SNTP client.
5. Configure the number of retries per SNTP server.
6. Configure an NTP server.
7. To add up to 10 SNTP servers, repeat step 6.
8. Enable the SNTP client.
Table 1: Variable definitions
Variable
<A.B.C.D>
<count>
<server>
<timeout>
24 Avaya Secure Router 1000 Series Configuration Guide
configure terminal
primary and secondary DNS servers.
ip pname_server <A.B.C.D>
ip name_server <A.B.C.D>
sntp
source-address <A.B.C.D>
retries <count>
server <server> [timeout]
enable
An IP address.
The number of retries the NTP server performs, in the range
1 to 5. Default is 3.
The NTP server to use for updates.
The maximum response time, in the range 10 to 7200. Default
is 1024.
Value
December 2010