Displaying Ospf Routes; Displaying Ip Routes; Ospf Nbma Over Ethernet - Avaya 1000 Series Configuration Manual

Displaying ospf routes

Execute show ip routes ospf on the SR1001 to display the OSPF routes learned from
neighbors. The following display shows the route 30.30.30.0/24, which was learned through
OSPF from the router advertisements.
Figure 33: show ip routes ospf Command
The metric shows a value of 2. By default, Avaya assigns a cost value of 1 to all interfaces.
The cost can be changed by entering it under the appropriate interface in the OSPF command
tree structure. For example:
SR/configure> router ospf
SR/configure/router/ospf> interface Dallas area_id 760
SR/configure/router/ospf/interface/Dallas> cost 10
SR/configure/router/ospf/interface/Dallas> exit 3
This would change the cost of bundle link Dallas from default (1) to 10. If the interface is already
configured, then entering area_id 760 is optional.

Displaying IP routes

Execute show ip routes to display all the active routes in the routing table.

OSPF NBMA over Ethernet

The Secure Router 1000 Series and 3120 will provide support for OSPF non-broadcast multi-
access (NBMA) over Ethernet. While it's well known that OSPF operates in peer-to-peer and
broadcast networks, its role in another kind of network can be just as important. A non-
broadcast network operates between point-to-point and broadcast networks, and doesn't
include broadcast or multicast functionality. Its purpose is to connect more than two devices
Avaya Secure Router 1000 Series Configuration Guide
Displaying ospf routes
December 2010 211