Table of Contents
Advertisement
PaRT 1 • English
to highlight the submenu of choice and press Ok proceed.
Use
pq
Press EXIT to leave.
7.4.1 Information
This submenu shows receiver specific information such as hardware version and software version. It also
displays our web address www . strong . tv. Please have the Information screen on hand when you call our
hotline. The person who answers your call might ask for the information given in this screen.
7.4.2 load factory Settings
This option allows you to reset the receiver to factory settings, which clears all stored channels.
Warning:
By resetting your receiver to factory default, all your settings and stored channels will
be permanently deleted. Please use this option with care.
to select Load Factory Settings in the Tools menu and press Ok. You are asked to input your PIN
Use
pq
code.
Input the correct PIN code using the 0~9 (DEfaUlT PIN: 1234). A confirmation window is displayed.
Select Yes to return to factory settings. Select No to cancel.
Press EXIT to leave.
7.4.3 S/W Upgrade by OTa
This receiver is equipped with an Over The Air software upgrade function. An Over The Air update might
not be available in your region. Please visit our website www . strong . tv or contact your local service
hotline for more information about this option.
7.4.4 Upgrade by USb
This feature allows you to upgrade receiver software via the USB port. When new software is available for
your receiver, it can be downloaded from our website www . strong . tv.
Place the software file (unzipped) in the root directory of your USB storage device (HDD, memory stick
etc.) and connect the device to the USB port of the receiver.
Select Upgrade by USB from the Tools menu and press Ok to proceed.
The upgrade menu will now be displayed.
Use
to select Upgrade Mode and choose option Allcode.
pq
Use
to select Upgrade File and choose the file containing the latest and correct software.
pq
Once all settings are made, move the highlight to Start and press Ok to start the upgrade process.
After a few seconds, the receiver asks: "Are you sure to burn flash?". Select Yes to finalize the upgrade or
No to quit without upgrading.
NOTE:
If, after a software upgrade, the receiver should behave in an unexpected way, please
perform a factory reset as well. See chapter 7.4.2.
Warning:
After an update the receiver restarts automatically. During the upgrade process
NEVER disconnect the receiver from the mains or switch off the power! Doing so
might damage your receiver and will void warranty!
7.4.5 auto-update OTa
If set to On the unit will check automatically at the moment of going to stand-by for an Over The Air
software upgrade. An Over The Air update might not be available in your region. Please visit our website
www.strong.tv or contact your local service hotline for more information about this option.
13
Advertisement
Table of Contents
