Tools - Strong SRT 8200 Picture similar User Manual

6.3.5 parental control
After selecting this menu and pressing ok you will be asked to enter the PIN code (DEfaUlT pIn: 0000).
This menu allows you to use the EPG based parental rating system, given this is supported by the local
broadcast.
Age:
ExamplE:
Your youngest child is 7 years old, so you have adjusted a rate of 07. You are switching
to a channel which is not foreseen for an age below 10 years, so at this channel you will
have to enter the PIN code (DEfaUlT pIn: 0000).
6.3.6 Reset factory Default
This option allows you to reset the receiver to the factory settings, which clears all stored channels and
settings.
WaRnIng: By resetting your receiver to the factory default, all your settings and stored channels
will be permanently deleted. Please use this option with care
After selecting this menu item and pressing ok you will be asked to enter the PIN code (DEfaUlT pIn:
0000). After you have performed this action you will be guided to the Installation Guide again!
If necessary, you can change the PIN code. To change the PIN code, please enter the Tools menu, see
chapter 6.4.3 of this manual.

6.4 Tools

Press mEnU and use t/u to select Tools then press ok. Following submenus will be displayed: Timers,
Information, Change Password, USB Upgrade, OAD Upgrade and Remove USB device.
Use p/q to select a submenu and press ok or u to access.
6.4.1 Timer
The timer function allows you to turn the receiver on and off according to the defined settings. Timers can be
set from the EPG in the most convenient way but you can also set timers manually through this menu.
In the menu Schedule, a summary of the configured timers will be displayed: number, channel name,
date, start and end time, repeat and timer status.
noTE:
If no timers have been configured, the list will be empty.
You can add, change or delete a timer.
Add:
Channel Type:
Channel No.:
Channel Name:
Start Date:
Start Time:
End Time:
Repeat:
Use t/u to change these settings. Following rates are available: OFF (to
disable the function), 04, 05, 06, 07, 08, 09, 10, 11, 12, 13, 14, 15, 16, 17 and 18.
Whenever switching through channels which submit EPG based parental rate
and the rate of the current broadcast is below the adjusted rate, you will have
to enter your PIN code.
To add a timer, press the RED button. In the new opened menu use t/u p/q
and 0-9 to configure the settings for the event. After the settings have been made,
set the necessary parameters and press ok to apply the timer into the list.
Use t/u to select between TV and radio programmes (the radio option is not
available if there are no radio channels broadcasted/in the channel list).
Use t/u to select the channel number to which you want to switch.
Here the channel name will be shown according to the channel number in above.
Use 0-9 to enter the date on which the timer should switch the receiver on.
Please consider the date format "dd/mm/yyyy. "
Use 0-9 to enter the start time.
Use 0-9 to enter the end time.
Use t/u to select in which cycle the timer should be repeated. Once - the
timer will switch ON once, after this the setting will be removed from timer list.
Daily - the timer will switch ON every day at the desired time. Weekly - the timer
will switch ON once a week at the desired time.
13