Controlling Other Components; Entering Remote Control Codes - Onkyo DV-SP1000 Instruction Manual

Controlling Other Components

In addition to controlling the DV-SP1000/DV-SP1000E,
the remote controller can also be used to control your TV
and VCR. To do this you need to enter the appropriate
control codes for your TV and VCR. The remote control-
ler can also learn individual commands from another
remote controller (see page 91).
STANDBY
Number
buttons

Entering Remote Control Codes

Entering the appropriate remote control code for your
TV and VCR will allow you to control them with the
DV-SP1000/DV-SP1000E's remote controller. You'll
need to perform this procedure twice to enter the codes
for both your TV and VCR.
1
Look up the appropriate remote
control code for your TV or VCR.
See "Remote Control Codes" on
page 87
2 While holding down the [VCR] or
[TV] MODE button, press the
Remote controller
[STANDBY] button, and then
MODE
release both buttons.
VCR TV
The Tx/Learn indicator flashes slowly
once, and then remains lit.
STANDBY
86
Tx/Learn
indicator
ON STANDBY
TV
I INPUT
+
1 2 3
TV CH
4 5 6 -
7 8 9
TV VOL
+ 10
0
CLEAR
SEARCH MEMORY DIMMER AMP INPUT
S M D
INPUT
AMP INPUT
DVD V1 V2 V3
TV
MODE
DVD AMP VCR TV
PICTURE
VCR
ZOOM ON CONTROL
AUDIO
SEL
+
CH
ZOOM ENTER VOL
L MODE
-
DISPLAY MUTING
LAST MEMORY STEP/SLOW RANDOM
REC LM RD
AUDIO SUBTITLE ANGLE RESOLUTION
AUDIO SBTTL ANGLE RSLTN
REPEAT A-B ASPECT
REPEAT A-B ASPECT
VIDEO INPUT VIDEO OFF LEARNING
V IN V OFF L1 L 2
OPEN/CLOSE
L 3 L 4
RC-563DV
3
Use the number buttons to enter
the 4-digit remote control code.
Remote controller
If the code is accepted, the Tx/
Learn indicator flashes slowly
1 2 3
twice.
4 5 6
If the Tx/Learn indicator flashes
7 8 9
quickly three times, the code has not
+ 10
0
been accepted, in which case you
should try again from step 2.
Notes:
• The learning mode will be cancelled if you don't press
any buttons for 30 seconds.
• In some cases, not all of the remote controller's but-
tons may work as expected.
• Individually learnt commands for the TV and VCR
modes (see page 91) are deleted when a new remote
control code is entered.