Connecting The Power Cord - Onkyo DV-SP1000 Instruction Manual

Connecting
Connect the IR receiver to the DV-SP1000/
DV-SP1000E as shown below.
from connecting block
Miniplug cable
IR
Controlling Other Out-of-range
Components
For another component that is out of range of its remote
controller, you can use a commercially available IR
emitter to retransmit the remote controller signals
received at the DV-SP1000/DV-SP1000E's IR IN, as
shown below.
Connecting
block
IR IN
IR OUT
DV-SP1000/
DV-SP1000E
IR emitter
Other
component
Connect the IR emitter to the DV-SP1000/
DV-SP1000E's IR OUT, and place the IR emitter in front
of the other AV component's remote control sensor (usu-
ally located on its front panel), as shown below. See the
instructions supplied with the IR emitter.
Other component
from connecting block
Miniplug cable
IR
Miniplug
IN
OUT
IR Emitter
DV-SP1000/
DV-SP1000E
Signal flow
IN
OUT
DV-SP1000/DV-SP1000E
IR receiver
Remote controller
Signal flow
Remote control
sensor
IR emitter
Signal flow
Only remote controller signals received by the
DV-SP1000/DV-SP1000E's IR IN are fed through to the
IR OUT. Signals picked up by the DV-SP1000/
DV-SP1000E's remote control sensor are not.

Connecting the Power Cord

Notes:
• Before connecting the power cord, complete all of the
necessary audio and video connections.
• Do not use a power cord other than the one supplied
with the DV-SP1000/DV-SP1000E, which is designed
exclusively for use with the DV-SP1000/
DV-SP1000E and should not be used with any other
component.
• Never disconnect the power cord from the
DV-SP1000/DV-SP1000E while the other end is still
plugged into a wall outlet. Doing so may cause an
electric shock. Always disconnect the power cord
from the wall outlet first.
• The DV-SP1000/DV-SP1000E (not the Canadian
model) is shipped with the POWER switch in the ON
position ( ). When the power cord is connected for
the very first time, the DV-SP1000/DV-SP1000E will
go on standby and the STANDBY indicator will light
up.
• To completely shutdown the DV-SP1000/
DV-SP1000E, set the POWER switch to the OFF posi-
tion ( ). (This does not apply to the Canadian model).
DVD CHANGER
DPC- 7.4
MODEL NO.
AC INLET
1
Plug the supplied power cord into the
DV-SP1000/DV-SP1000E's AC INLET.
2
Plug the other end of the power cord into
a suitable AC wall outlet.
The STANDBY indicator lights up.
The STANDBY indicator comes on only if the
POWER switch is in the ON ( ) position. (This
does not apply to the Canadian model).
41