Sacd Audio Setup - Onkyo DV-SP1000 Instruction Manual

Configuring the DV-SP1000/DV-SP1000E
2
Use the Left and Right [
buttons to set the delay time.
1
2
3
3
When you've finished, press the
[SETUP] button.
Remote controller
The settings are stored.
Notes:
• This setting affects only the analog multichannel out-
put. To delay audio from the other outputs, use the
delay settings (i.e., the speaker distance settings) on
the connected AV receiver.
• The AV Synchronization setting has no effect on
SACD (multichannel area and 2-channel area) and
196 kHz/176.4 kHz DVD-Audio.
Dynamic Range Control (Dolby Digital
only)
DVD-V DVD-A
With the Dynamic Range Control you can reduce the
dynamic range of Dolby Digital material so that you can
still hear quiet parts even when listening at low volume
levels—ideal for watching movies late at night when you
don't want to disturb anyone.
Off (default)
The full dynamic range is preserved.
On
The dynamic range is reduced.
Notes:
• The impact of the Dynamic Range Control depends on
the Dolby Digital material that you are playing and
with some material there will be little or no effect.
• This setting automatically reverts to Off when the DV-
SP1000/DV-SP1000E is turned on.
80
Memory Range
0–100 ms

SACD Audio Setup

]/[ ]
SACD
SACDs have two separate areas for storing audio
Default tracks—one for multichannel audio, the other for 2-
channel stereo audio. In addition, hybrid SACDs have
0 ms
an extra layer for playback in standard CD players.
50 ms
With this setting you can determine how SACDs are
50 ms
played by the DV-SP1000/DV-SP1000E.
2 ch Area
The 2-channel stereo audio
Multi ch Area (default)
The multichannel audio
CD Area
The CD layer of hybrid SACDs is played.
Notes:
• If Multi ch Area is selected, and an SACD that con-
tains no multichannel area is loaded, the 2-channel
area will be played.
CD Audio Setup
CD
This setting configures the digital audio outputs for use
with normal CDs or DTS CDs.
PCM (default)
Choose this option when playing normal audio CDs.
DTS
Choose this option when playing DTS CDs.
Notes:
• This setting can be set only when the DTS Out setting
for Digital Out/Digital 1 or 2 is set to "DTS->PCM."
tracks are played.
tracks are played.