Oneida Air Systems 5 & 7.5 HP Direct Drive Cyclonic Dust Collectors Owner's Manual page 8

VI. Assembly Instructions
Fan / Blower is shipped strapped to Cyclone Barrel. It is NOT
attached to the unit. You must bolt them together. Follow the
instructions below.
1. Orient the blower housing to match the stand
configuration and the desired angle for the cyclone inlet.
Bolt the fan / blower to the cyclone barrel using the
hardware taped on the motor.
Bolts are already welded on Fan/Blower unit. Put a bead
of silicone around top hole in cyclone barrel, then put
bolts through holes in barrel. Put flat washer on bolt.
then lock washer, then hex nut.
Cyclone Inlet and Fan / Blower are independent.
Filters can be to the right or left of the unit.
16 ea. 3/8" Flat Washers, Lock Washers and Hex Nuts
2. Bolt the fan housing and cyclone barrel to the cyclone
cone using hardware taped to cyclone barrel. Note: the
fan / blower and the cyclone barrel are very heavy. The
system will be top heavy. One method is to lay the stand
down, then bolt the cyclone with the fan / blower to the
stand. The iron ring will be on top of the cross bars of
the stand. Put bead of silicone around inside edge of
flange on the cyclone cone. Then put bolt through flat
washer, then bolt through holes in both flanges, thenput
lock washer on bolt, then attach hex nut.
16 ea. 3/8" Flat Washers,
Lock Washers, Hex Nuts
and 3/8 x 1" Bolts
3. Tip the fan housing and cone upright. The system is
very top heavy. Place plenum on top of the plenum
stand.
4. Bolt the plenum to the fan housing outlet (rectangular).
Clamp the cartridges to the plenum. Clamp the dust
bins to the bottom of the cartridge filters.
Continued on next page.
5 - 7.5 HP Direct Drive Owner's Manual
Bolt
Flat Washer
Flange
Lock Washer
Hex Nut
c
O.A.S. 2002
1.
Air
Outlet
Silicone
Bead
2.
Silicone
Bead
3.
Plenum
Stand
Cartridge
Filters
Dust Bins
Fan / Blower
Air Inlet
Cyclone
Barrel
Cyclone
Barrel
Cyclone
Cone
Outlet
7