System Start-Up Information - Oneida Air Systems 5 & 7.5 HP Direct Drive Cyclonic Dust Collectors Owner's Manual

I. System Start-Up Information
1. Read the installation and maintenance instructions as well as the recommended
safety practices in this manual.
2. Install Ductwork completely:
A.) Seal ductwork with silicone sealant or duct tape.
B.) Have Dust Bin in place and sealed before running Dust Collector.
3. Wire Fan / Blower according to wire diagram on pg. 11 in this owner's manual.
4. Have a licensed electrician check current draw on motor with all gates open. Current
draw should not exceed maximum motor amperage. (OAS is not responsible for
destroyed motors.)
The Direct Drive Fan / Blower makes the system top heavy!
Use extreme care when setting the unit up!
Do not operate Fan / Blower unless Cyclone and Dust Bin
Check amperage draw during operation with all blast gates
open. Make certain amperage is not outside operating limit
If amperage is too high - shut down immediately!
2
Caution
Warning
are in place. Motor will over heat!
Warning
indicated on motor plate!
Warning
(See troubleshooting section.)
5 - 7.5 HP Direct Drive Owner's Manual
c
O.A.S. 2002