IX. Single and Three Phase Wire Diagram
Use wiring diagram on motor plate if different from below.
Wiring should always be done by a licensed electrician!
- Electrically insulate all connections.
- For counter-clockwise rotation, looking from top of motor down.
5hp Single Phase
Leeson Motor / 230v / 19.8 amps / TEFC / C Face / 3500 rpm
P1
Power Line 1*
T1
Tie together and insulate with
a wire nut (do NOT connect to
T8
any house wiring)
T4
Power Line 2*
T5
* Power Line 1 and 2 are interchangeable
7.5hp Three Phase
Leeson Motor / 208 - 230/460v / 19.6 - 18.4/9.2 amps / TEFC / C Face
/ 3480 rpm
208 / 230 Volts
L1
T1 & T7
L2
T2 & T8
L3
T3 & T9
T4
T5
Tie together
T6
To Line to reverse rotation interchange any two line leads
Check rotation after wiring.
Wire for counter-clockwise rotation.
11
460 Volts
L1
T1
L2
T2
L3
T3
Tie together
T7 & T4
Tie together
T8 & T5
Tie together
T9 & T6
Outlet
Motor
Wire
Box
Green
Chassis
Screw
Ground: Connect house ground
wire to green chassis screw in
motor wire housing box.
5 - 7.5 HP Direct Drive Owner's Manual
Top View
Inlet
c
O.A.S. 2002