Arctic Cat Pantera 3000 Service Manual page 63

SNO-2219
14. Secure the right-side steering boot to the chassis
using the existing push rivets.
XM134A
15. Secure the top of the steering post to the steering
support using the existing retaining plate and nuts
making sure the throttle cable is routed between the
steering bushings. Tighten to 96 in.-lb.
16. Install the air intake assembly and secure the intake
boots to the throttle body using the existing clamps.
Tighten to 11 in.-lb.
17. Install the vent hoses into the air intake; then connect
the air temperature sensor.
YM-036
18. Install the fuse block onto the coolant tank; then
secure the front fascia to the chassis using the exist-
ing screws.
19. Install the radiator assembly into the lower radiator
hose; then install the upper radiator hose to the filler
neck. Secure using existing clamps.
20. Connect the radiator fan to the main harness; then
secure the top of the radiator to the air intake using
the hold down bracket and both screws. Tighten
securely.
62
YM-035A
21. Position the exhaust gasket between the engine and
the exhaust manifold; then secure the manifold to the
engine using the existing screws. Tighten to 16 ft-lb.
YM-136
22. Secure the heat shield over the manifold using the
existing brackets, two flat washers, and all five
screws. Tighten to 8 ft-lb.
YM-135A
23. Secure the front of the heat shield to the side support
using the existing cap screw and nut. Tighten
securely.