Arctic Cat Pantera 3000 Service Manual page 108

ZJ086
39. Install the cam chain tensioner adjuster by first com-
pressing the locking clip; then by pushing in the ten-
sioner shaft until completely compressed.
ZJ085A
40. Install the tensioner and secure with two Allen-head
cap screws; then tighten to 84 in.-lb. Install the ball,
spring, and tensioner bolt and tighten to 18 ft-lb.
41. Install the engine cover alignment pins; then install
the engine cover and secure with four cap screws and
plastic washers. Using the pattern shown, tighten the
cap screws to 120 in.-lb.
741-580A
 NOTE: At this point, install the spark plugs.
42. Place the starter gear on the crankshaft; then install
the flywheel key.
ZJ036A
43. Install the flywheel with the cap screw and washer.
Using the flywheel holder wrench from Flywheel
Puller, tighten the cap screw to 88 ft-lb.
ZJ087
44. Install the oil scavenge pump alignment pins in the
engine case; then with the inner and outer seals (A)
in place on the pump, install the pump and secure
with the four cap screws (B). Tighten to 84 in.-lb.
0742-125
45. With the two pins installed in the engine case, first
install the starter torque limiter (A) and spacer (B);
then install the inner spacer (C), idler gear (D), and
outer spacer (E).
107