Arctic Cat Pantera 3000 Service Manual page 54

NOTE: On the 9000, secure the front heat shield to

the chassis with the screws.
PC058A
 NOTE: On the 5000, install the MAP sensor to the
bracket on the MAG-side steering support.
PC029A
26. With the throttle cable in place, install and secure the
steering post to the steering bracket with the mount-
ing blocks, cap screws, and lock nuts. Tighten to 96
in.-lb.
PC030
27. Install and secure the handlebar to the steering post
with the caps and four cap screws. Tighten the cap
screws to 15 ft-lb.
NOTE: Connect the handlebar harness to the main

harness connector and secure the connectors to the
harness at the PTO-side steering support.
PC061A
28. Install the throttle cable into the lever; then verify the
throttle lever free-play is within specification.
0741-518A
NOTE: Steps 29-32 are for the 9000 only.

29. Install the fascia and install the front pins (B) of the
intercooler into the brackets; then install the rear
brackets (A) to the pins of the intercooler and secure
the brackets to the chassis with cap screws and lock
nuts. Tighten securely.
PC056A
30. Install and secure the turbocharger/intercooler hose
and air intake hose; then secure the intercooler hose
to the throttle body.
53