Arctic Cat Pantera 3000 Service Manual page 211

YM-099
18. Install the reverse sprockets and chain; then place the
existing thrust washer on the outside of the upper
reverse sprocket.
19. Secure the driveshaft reverse sprocket to the drivesh-
aft with a snap ring; then install a existing thrust
washer on the outside of the upper reverse sprocket
and reverse idler shaft.
YM-094
20. Install the reverse gear, fork, shift shaft, and shift
rack assembly into the chain case.
YM-100
21. Install the chain case cover/oil tank assembly and
secure with the screws. Tighten in a crisscross pat-
tern to 14 ft-lb.
22. Fill the chain case with 12 oz of Arctic Cat Chain
Lube.
 NOTE: Make sure the gear position sensor wires are
routed up and over the top side of the actuator so they
are not pinched when installing the reverse shift actu-
ator.
210
SNO-982
 NOTE: Be sure to add a small amount of white lith-
ium grease to the O-rings of the new actuator exten-
sion and the shift actuator detent block before
installing.
23. Install the actuator extension and gently rotate
counter clockwise to make sure the shift fork is in the
forward position. When the shift fork is in the for-
ward position, make sure the notch in the extension
is directed downward.
YM-101
24. Install spring into the bottom of shift actuator detent
block and install into the chain case cover. The notch
in the extension should be lined up with the notch in
the block.
YM-102
 NOTE: To verify everything is installed correctly,
turn the extension counter clockwise. The notch in the
extension should not rotate out of the detent block.
25. Rotate the extension clockwise approximately 20°
making sure not to pull out the extension when rotat-
ing. This is only to aid in the installation of the actu-
ator.