Arctic Cat Pantera 3000 Service Manual page 210

YM-054
12. Install the drive clutch and tighten the clutch cap
screw to 51 ft-lb; then install the driven clutch and
drive belt. Tighten to 20 ft-lb (threads coated with
blue Loctite #243).
13. With the driveshaft installed into the chain case,
install the existing thrust washer and secure with the
silver snap ring making sure it is fully seated into the
groove closest to the bearing.
YM-096
14. Install the black snap ring into the groove on the
driveshaft making sure it is fully seated into the
groove; then install the thrust washer up against the
snap ring.
YM-098
15. On 3000, 5000, and 9000 models, install the chain
and sprockets; then install the ratchet block making
sure to have the tensioner on the fifth notch.
PC085A
 NOTE: On 7000 models, turn the chain tension
adjustment bolt clockwise until it is finger tight; then
loosen it 1 1/2 turns. While holding the bolt with a
wrench, tighten the jam nut to 18 ft-lb.
YM-053
16. Secure the top sprocket using the existing thrust
washer and black snap ring making sure it is fully
seated into the groove.
YM-097
17. Before installing the reverse sprockets and chain, be
sure the reverse shaft and thrust washer are installed
into the chain case.
209