Arctic Cat Pantera 3000 Service Manual page 163

XM426
4. Loosen the nut securing the throttle cable; then
remove the cable and the throttle body assembly.
XM406
ASSEMBLING/INSTALLING (3000)
1. Install the throttle cable to the throttle body and
secure using the existing jam nuts. Tighten securely.
XM406
2. Connect the main harness to both injectors; then con-
nect all other connections on the throttle body and
secure the harness using the existing clamp and
screw. Tighten securely.
162
XM404
3. Position the air intake silencer onto the throttle body
and the intake tube. Secure using the existing hose
clamps. Tighten to 35 in.-lb.
4. Connect main harness to the coils; then connect the
coils to the spark plugs making sure to firmly press
down the spark plug caps to secure.
5. Secure the air silencer to the tunnel using the three
screws. Tighten securely.
XM427
6. Install the gas tank assembly, seat, hood, and both
access panels.
REMOVING/DISASSEMBLING (5000)
NOTE: To remove the throttle body assembly, it is

necessary to remove the air silencer. The seat and gas
tank must also be removed.
1. Remove the coolant hoses and MAP sensor hoses
from the throttle body.
ZJ018A