Radiator - Can-Am Renegade 500 Operator's Manual

vmo2006-007-019_a
TYPICAL
1. Oil drain plug
2. Brake pedal
Allow enough time for oil to flow out
of oil filter.
Remove the right engine cover.
Unscrew the oil filter cover.
vmo2006-007-020_a
1. Oil filter cover
Remove the oil filter and replace with
a new filter.
Check the cover O-ring and change it
if necessary.
Screw oil filter cover in place.
Wipe out any oil spillage on engine.
Change gasket on oil drain plug. Clean
gasket area on engine and oil drain
plug then reinstall plug. Refill engine
at the proper level with the recom-
mended oil. Refer to SPECIFICA-
TIONS for capacity.
_____________________
106
Start engine and let idle for a few min-
utes. Ensure oil filter area and oil drain
plug areas are not leaking.
Stop engine. Wait a while to allow oil
to flow down to crankcase then check
oil level. Refill as necessary.
Dispose of oil as per your local envi-
ronmental regulations.

Radiator

Periodically check the radiator area for
cleanliness.
vmo2007-015-012_a
1. Radiator
Inspect radiating fins. They must be
clean, free of mud, dirt, leaves and any
other deposit that would prevent the
radiator to cool properly.
Remove as much deposits as you can
with your hands. If water is available
in proximity, try rinsing the radiating
fins.
If available, use a garden hose to rinse
the radiating fins.
WARNING
Never clean radiator with your
hands when it is hot. Let the radi-
ator cool down before cleaning.