Can-Am outlander 400 series Operator's Manual page 85

Display Selector Button
Use selector
speedometer display to the desired
mode:
– hourmeter (resetable)
– odometer
– trip meter 1 (resetable)
– trip meter 2 (resetable)
vmo2006-005-015_b
1. Selector button
Multi-Function Display
Odometer (ODO)
Odometer records the total distance
travelled either in miles or kilometers.
Trip Meter (TRIP 1/TRIP 2)
For your convenience,
speedometer
two separate trip meter.
The trip meter records distance trav-
elled since it has been reset. Distance
travelled is displayed either in miles or
kilometers.
It can be used to establish a fuel tank
range or distance between 2 way
points for instance.
Push and HOLD display selection but-
ton for 2 seconds to reset the trip me-
ter.
button to change
is equipped
Hourmeter
Transmission Position (RANGE)
4-Wheel Drive System
Indicator Lamps
High Intensity (BLUE)
When this indicator light is ON,
it indicates high intensity is
your selected on the headlamps.
with
Oil Pressure (RED)
When this indicator light is ON,
it indicates a low oil pressure
condition of the engine.
CAUTION: If the light does not turn
off right after engine starting, stop
engine. See an authorized Can-Am
ATV distributor/dealer. Do not use
the vehicle until repaired.
_____________________
The hourmeter
engine running time in hours
and minutes.
Indicates the transmission is
in park position.
Indicates the transmission is
in reverse position.
Indicates the transmission is
in neutral position.
Indicates the 4WD system
is activated.
records
83