Loaded Operation - Omron I537-E2-01 User Manual

‹

Loaded Operation

„
Connecting the Load
• After confirming that the motor has stopped completely, connect the mechanical system.
• Be sure to tighten all the screws when securing the motor shaft to the mechanical system.
„
Operation using the Digital Operator
• Use the Digital Operator to start operation in LOCAL mode in the same way as in no-load operation.
If fault occurs during operation, make sure the STOP Key on the Digital Operator is easily accessible.
•
At first, set the frequency reference to a low speed of one tenth the normal operating speed.
•
„
Checking Operating Status
Having checked that the operating direction is correct and that the machine is operating smoothly at slow
•
speed, increase the frequency reference.
After changing the frequency reference or the rotation direction, check that there is no oscillation or abnor-
•
mal sound from the motor. Check the monitor display to ensure that U1-03 (Output Current) is not to high.
Refer to Adjustment Suggestions on page 4-13 if hunting, vibration or other problems originating in the
•
control system occur.
„
Check and Recording Parameters
Use verify mode (i.e., when the VERIFY indicator on the Digital Operator is lit) to check parameters that have
been changed for trial operation and record them in a parameter table.
Any parameters that have been changed by autotuning will also be displayed in verify mode.
If required, the copy function in parameters o3-01 and o3-02 displayed in advanced programming mode can
be used to copy the changed settings from the Inverter to a recording area in the Digital Operator. If changed
settings are saved in the Digital Operator, they can be easily copied back to the Inverter to speed up system
recovery if for any reason the Inverter has to be replaced.
The following functions can also be used to manage parameters.
Recording parameters
•
Setting access levels for parameters
•
• Setting a password
„
Recording parameters (o2-03)
If o2-03 is set to 1 after completing trial operation, the settings of parameters will be saved in a separate mem-
ory area in the Inverter. When the Inverter settings have been changed for any reason, the parameters can be
initialized to the settings saved in the separate memory area by setting A1-03 (Initialize) to 1110.
„
Parameter Access Levels (A1-01)
A1-01 can be set to 0 (monitoring-only) to prevent parameters from being changed. If A1-01 is set to 2
(advanced programming) all parameters can be read or written.
Trial Operation Procedures
11
4-