Removing The Oil Filter; Installing The Oil Filter - KTM 450 EXC Owner's Manual

Hide thumbs Also See for 450 EXC:
Table of Contents

Advertisement

SERVICE WORK ON THE ENGINE

Removing the oil filter

x
16.4
Warning
Danger of scalding Engine oil and gear oil get very hot when the motorcycle is ridden.
Wear appropriate protective clothing and safety gloves. In case of burns, rinse immediately with lukewarm water.
Warning
Environmental hazard Hazardous substances cause environmental damage.
Oil, grease, filters, fuel, cleaners, brake fluid, etc., should be disposed of as stipulated in applicable regulations.

Installing the oil filter

x
16.5
Place a suitable container under the engine.
Remove screws
200113-10
Pull the oil filter insert
Circlip pliers reverse (51012011000)
Completely drain the engine oil.
Thoroughly clean parts and sealing surface.
200114-10
Lay the motorcycle on its side and fill the oil filter housing to about ⅓ full with
engine oil.
Fill the oil filter
Lubricate the O/ring
200114-11
Refit the oil filter cover
Mount and tighten screws
Guideline
Screw, oil filter cover
Stand the motorcycle upright.
200113-11
. Remove oil filter cover
out of the oil filter casing.
with engine oil and place it in the oil filter container.
of the oil filter cover.
.
.
M6
with the O-ring.
10 Nm (7.4 lbf ft)
88

Advertisement

Table of Contents
loading

This manual is also suitable for:

530 exc

Table of Contents