KTM 450 EXC Owner's Manual page 71
Hide thumbs
Also See for 450 EXC:
- Owner's manual (136 pages) ,
- Setup instructions (31 pages) ,
- Owner's manual (70 pages)
Table of Contents
Advertisement
BRAKES
–
Stand the vehicle upright.
–
Remove screw cap
–
Press the brake piston back to its basic position and make sure that no brake fluid
overflows from the brake fluid reservoir.
Info
Make sure when pushing back the brake piston that you do not press the
brake caliper against the spokes.
100807-10
–
Remove locking split pins
–
Clean brake caliper and brake caliper support.
100808-10
–
Check that anti-squeal shim
brake caliper support are seated correctly.
100407-10
–
Fit the brake pads, insert the bolt, and mount the locking split pins.
–
Operate the foot brake lever repeatedly until the brake linings are in contact with
the brake disc and there is a pressure point.
100408-01
–
Correct the brake fluid reservoir level to the marking
Brake fluid DOT 4 / DOT 5.1 (
–
Mount the screw cap
Info
Clean up overflowed or spilt brake fluid immediately with water.
400233-10
with membrane
and the O-ring.
, withdraw bolt
, and take out the brake pads.
in the brake caliper and anti-rattle shim
p. 108)
with the membrane
and the O-ring.
69
in the
.
Advertisement
Table of Contents
