Riding Instructions; Checks And Maintenance Before Putting Into Operation; Starting - KTM 450 EXC Owner's Manual

RIDING INSTRUCTIONS

Checks and maintenance before putting into operation

7.1
Info
The motorcycle must always be in perfect technical condition before use.
Before every trip, check the condition of the vehicle and ensure that it is safe to operate.
–
Check the engine oil level. (
–
Check the electrical system.
–
Check the brake fluid level of the front brake. (
–
Check the rear brake fluid level. (
–
Check the front brake linings. (
–
Check the rear brake linings. (
–
Check the brake system function.
–
Check the coolant level. (
–
Check for chain dirt accumulation. (
–
Check the chain, rear sprocket, engine sprocket and chain guide. (
–
Check the chain tension. (
–
Check the tire condition. (
–
Check the tire air pressure. (
–
Clean the dust boots of the fork legs. (
–
Bleed fork legs. ( p. 44)
–
Check the air filter.
–
Check the settings of all controls and ensure that they can be operated smoothly.
–
Check all screws, nuts and hose clamps regularly for tightness.
–
Check the fuel reserves.

Starting

7.2
Danger
Danger of poisoning Exhaust gases are poisonous and inhaling them may result in unconsciousness and/or death.
–
When running the engine, always make sure there is sufficient ventilation, and do not start or run the engine in an enclosed
space without an effective exhaust extraction system.
Note
Engine failure High engine speeds in cold engines have a negative effect on the service life of the engine.
–
Always warm up the engine at low engine speeds.
Info
If the motorcycle is unwilling to start, the cause may be old fuel in the float chamber. The flammable elements of the fuel
evaporate after a long time of standing.
If the float chamber is filled with fresh fuel, the engine starts immediately.
Press the starter for a maximum of 5 seconds. Wait for a least 5 seconds before trying again.
p. 87)
p. 63)
p. 67)
p. 64)
p. 68)
p. 80)
p. 54)
p. 55)
p. 72)
p. 73)
p. 44)
Motorcycle has been out of use for more than 1 week
–
Empty the carburetor float chamber.
–
Turn handle
Fuel can flow from the fuel tank to the carburetor.
–
Raise the motorcycle off of the stand and secure the stand with rubber band
–
Shift transmission to neutral.
–
Turn the key in the ignition switch to the position .
–
Turn the emergency OFF switch to the position .
The engine is cold
–
Pull choke lever out as far as possible.
100842-10
p. 57)
x
of the fuel tap to the ON position. (Figure 500137-10

( p. 85)
p. 22)
31
.
