Removing The Seat; Mounting The Seat; Removing The Air Filter Box Lid; Installing The Air Filter Box Lid - KTM 450 EXC Owner's Manual

SERVICE WORK ON THE CHASSIS

Removing the seat

10.20

Mounting the seat

10.21

Removing the air filter box lid

10.22

Installing the air filter box lid

10.23

Removing the air filter

x
10.24
Note
Engine failure Unfiltered intake air has a negative effect on the service life of the engine.
–
Never ride the vehicle without an air filter since dust and dirt can get into the engine and result in increased wear.
Warning
Environmental hazard Hazardous substances cause environmental damage.
–
Oil, grease, filters, fuel, cleaners, brake fluid, etc., should be disposed of as stipulated in applicable regulations.
–
Remove screw
above.
500080-10
–
Hook in the front of the seat at the collar sleeve of the fuel tank, lower it at the rear
and simultaneously push it forward.
–
Make sure that the seat is correctly locked in.
–
Mount and tighten the screw of the seat fixing.
Guideline
Remaining screws, chassis
500068-01
–
Pull off the air filter box lid in area
800021-10
–
Insert the air filter box lid into the rear area
800021-11
–
Remove the air filter box lid. (
. Lift up the seat at the rear, pull it back and then remove from

M6
to the side and remove to the front.

p. 50)
10 Nm (7.4 lbf ft)
and clip it into the front area

50
.
