Creating A Project File - Omron SYSDRIVE 3G3JV User Manual

Communications
H Data Created by Protocol Support Tool
• A project file is used by the Protocol Support Tool to create and control data.
A project file consists of the following data.
Single project file
Protocol name
(Single protocol)
Note The standard system protocol incorporated by the Communications Board cannot be edited or
transferred. To make use of the standard system protocol, copy it to the project file and edit it.
In 7-10-4 Creating a Project File, an example to create a new project file is shown without making
use of the standard system protocol.

7-10-4 Creating a Project File

• The following description provides information about how to create a project file to issue the RUN com-
mand and frequency reference and read the Inverter status.
H Design
• Select from I/O items, monitor items, and parameters the data to be exchanged according to the
application. Then consider what sequence is required by using the protocol macro function.
Example: Writes control input items (such as the RUN command and multi-function input) of the
Inverter and frequency reference, monitors the control output (such as error output and RUN out-
7-40
Protocol list
Trace list
PLC
Sequence 000/Sequence name
Sequence 001/Sequence name
Sequence 999/Sequence name
Send message list
Recv message list
Recv matrix
Sequence #jjj
Protocol name
Protocol name
Protocol name
Message name
Message name
Message name
Message name
Matrix name
Matrix name
Step 00
Step 01
Step 15
Chapter 7
A maximum of 20 protocols
(A maximum of 1,000
sequences per project)
A maximum of 60
sequences/protocol
The first sequence number
and last sequence number
are specified by each
protocol.
A maximum of
300 messages
A maximum of
100 matrixes
A maximum of 16 steps