Omron SYSDRIVE 3G3JV User Manual page 103

Basic Operation
Set Values
Value Function
0 Fault output
1 Operation in progress
2 Frequency detection
3 Idling
4 Frequency detection 1
5 Frequency detection 2
6 Overtorque being
monitored (NO-contact
output)
7 Overtorque being
monitored (NC-contact
output)
10 Alarm output
11 Base block in progress
12 RUN mode
13 Inverter ready
14 Fault retry
15 UV in progress
16 Rotating in reverse
direction
17 Speed search in progress
Note Use "operation in progress" (set value: 1) or "idling" (set value: 3) setting for the timing for stopping
the motor using a brake. To specify a precise stop timing, set "frequency detection 1" (set value: 4)
or "frequency detection 2" (set value: 5), and set the frequency detection level (n58).
5-22
ON: Fault output (with protective function working)
ON: Operation in progress (with RUN command input or inverter
output)
ON: Frequency detection (with frequency reference coinciding with
output frequency)
ON: Idling (at less than min. output frequency)
ON: Output frequency y frequency detection level (n58)
ON: Output frequency x frequency detection level (n58)
Output if any of the following parameter conditions is satisfied.
• Overtorque detection function selection (n59)
• Overtorque detection level (n60)
Overtorque detection level (n60)
• Overtorque detection time (n61)
Note NO contact: ON with overtorque being detected; NC contact:
OFF with overtorque being detected
ON: Alarm being detected (Nonfatal error being detected)
ON: Base block in progress (in operation with output shutoff)
ON: Local mode (with the Digital Operator)
ON: Inverter ready to operate (with no fault detected)
ON: Fault retry (Inverter resetting with fault retry (n48) not set to 0)
ON: Undervoltage being monitored (main circuit undervoltage UV or
UV1 detected)
ON: Rotating in reverse direction
ON: Speed search in progress
Description
Chapter 5