Omron SYSDRIVE 3G3JV User Manual page 227

List of Parameters
Parame- Name
ter No.
(Register
No.
(Hex))
n01 Parameter Used to prohibit parameters to be written, sets
write-pro- parameters, or change the monitor range of
(0101)
hibit selec- parameters.
tion/
Used to initialize parameters to default values.
parameter
initializa- 0: Sets or monitors parameter n01. Parame-
tion
1: Sets or monitors parameters n01 through
5: Enables continuous operation. (Parameters
6: Clears the error log.
8: Initializes parameters to default values in
9: Initializes parameters to default values in
Note
n02 Operation Used to select the input method for the RUN
command and STOP commands in remote mode.
(0102)
selection
0: The RUN and STOP/RESET Keys on the
1: Multi-function inputs through the control cir-
2: Operation commands via RS-422/485 com-
Note
n03 Frequency Used to set the input method for the frequency
reference reference in remote mode.
(0103)
selection
0: Digital Operator
1: Frequency reference 1 (n21)
2: Frequency reference control circuit terminal
3: Frequency reference control circuit terminal
4: Frequency reference control circuit terminal
6: Frequency reference via RS-422/485 com-
n04 Interrup- Used to set the stopping method for use when
tion mode the STOP command is input.
(0104)
selection
0: Decelerates to stop in preset time.
1: Coasts to stop (with output shut off by the
n05 Reverse Used to select the operation with the reverse
rotation- command input.
(0105)
prohibit
0: Reverse enabled.
selection
1: Reverse disabled.
10-2
Description
ters n02 through n79 can be monitored
only.
n79.
n01 to n79 can be set or monitored.)
2-wire sequence.
3-wire sequence.
With settings 0 or 1, operation com-
mands are ignored in Program Mode.
(Refer to 3-1-2 Drive Mode and Pro-
gram Mode.) Normally, use a setting of
0 or 1.
Digital Operator are enabled.
cuit terminals in 2- or 3-wire sequence.
munications are enabled.
The RUN command only through key
sequences on the Digital Operator is
acceptable in local mode.
(0 to 10 V)
(4 to 20 mA)
(0 to 20 mA)
munications
STOP command)
Setting Unit of Default
range setting setting
0, 1, 6, 8, 1 1
9
0 to 2 1 0
0 to 4, 6 1 0
0, 1 1 0
0, 1 1 0
Chapter 10
Changes Refer-
during op- ence
eration page
No 5-2
No 5-7
No 5-8
No 5-17
No 5-16