Omron SYSDRIVE 3G3JV User Manual page 71

Preparing for Operation and Monitoring
H Verifying Parameters (vFy)
The parameter settings saved in the memory of the Digital Operator can be verified with the parameter
settings in the Inverter by setting the Parameter Copy and Verify Function (n76) to "vFy."
Note Just as with copying, parameters can be verified only for Inverters that have the same power sup-
ply specifications.
D Procedure for Verifying Parameters
Key sequence Indicators
(After
completion)
or
Note 1. Verification will be cancelled and the display will change to "End" if the STOP/RESET Key is
pressed while the number of an inconsistent parameter is being displayed or the setting is
being displayed. The display will then return to the number of the inconsistent parameter
when the Mode Key or the Enter Key is pressed.
Note 2. The display will flash "vAE" if you attempt to verify parameters between Inverters that have
different capacities. To continue verifying anyway, press the Enter Key. To cancel verifying,
press the STOP/RESET Key.
Display
example
Power ON
Press the Mode Key until the PRGM indicator lights.
Use the Increment or Decrement Key to display n76.
Press the Enter Key. "rdy" will be displayed.
Press the Increment Key to display "vFy."
Press the Enter Key. The parameters will be verified.
(During this time, the display will flash.)
If the settings of a parameter do not match, the
parameter number of the inconsistent parameter will
be flashed on the display.
The setting in the Inverter will be flashed first when the
Enter Key is pressed.
When the Enter Key is pressed again, the setting in the
Digital Operator will be flashed.
Verification will be continued when the Increment Key
is pressed.
When the verification has been completed, "End" will
be displayed.
Press the Mode Key or the Enter Key to return to the
parameter number display.
Chapter 3
Explanation
3-15