Omron SYSDRIVE 3G3JV User Manual page 232

List of Parameters
Parame- Name
ter No.
(Register
No.
(Hex))
Description
12 External base ON: Output shut off (while
block com- motor coasting to a stop
mand (NO) and "bb" flashing)
13 External base OFF: Output shut off (with
block com- motor free running and
mand (NC) "bb" flashing)
14 Search com- ON: Speed search
mand (Search- (Searching starts from
ing starts from n09)
maximum fre-
quency)
15 Search com- ON: Speed search
mand (Search-
ing starts from
preset fre-
quency)
16 Acceleration/ ON: Acceleration/Decel-
Deceleration- eration is on hold (running
prohibit com- at parameter frequency)
mand
17 Local or re- ON: Local mode (operated
mote selection with the Digital Operator)
18 Communica- ON: RS-422/485 commu-
tions or nications input is enabled.
remote selec- OFF: The settings of n02
tion and n03 are enabled.
19 Emergency The Inverter stops accord-
ing to the setting in n04 for
stop fault (NO)
interruption mode selec-
tion with the emergency tion with the emergency
20 Emergency stop input turned ON.
stop alarm
NO: Emergency stop with
(NO)
the contact closed.
NC: Emergency stop with
th the contact opened.
21 Emergency
stop fault (NC) Fault: Fault output is ON
and reset with RESET
input. Alarm output is ON input. Alarm output is ON
22 Emergency (no reset required).
stop alarm
"STP" is displayed (lit with
(NC)
fault input ON and flashes
with alarm input ON)
34 Up or down Up or down command (set
command in n39 only)
By setting n39 to 34, the
set value in n38 is ignored
and the following setting
are forcibly made.
S4: Up command
S5: Down command
35 Self-diagnostic ON: RS-422/485 commu-
test nications self-diagnostic
test (set in n39 only)
Setting
range
g y p
t t d
Chapter 10
Unit of Default Changes
setting setting during
operation
1 6 No
Refer-
ence
page
5-18
10-7