Ignition Switch; Brake Pedal; Footpeg; Grab Handles - Can-Am MAX 400 EFI Operator's Manual

12) Ignition Switch

Key-operated, 3-position switch.
vmo2008-019-009_a
IGNITION SWITCH POSITIONS
1. OFF
2. ON with lights
3. ON without lights
NOTE: The engine stop switch will
override the ignition switch. Make
sure engine stop switch is in RUN
position to allow electrical system ac-
tivation.
Insert key in switch and turn to the
desired position.
To remove key, turn key to OFF posi-
tion then pull it out.
The ON with lights position, turns on
all lights with either the engine run-
ning or not. Remember that having
the lights on without the engine run-
ning discharges the battery. Always
turn the ignition key to OFF position af-
ter engine has been stopped.

13) Brake Pedal

When pressed down, the rear brake is
applied.
When released,
should return to its original position.
Braking effect is proportional to the
force applied on the pedal and to the
type and condition of the terrain.
NOTE: The brake will have also an ef-
fect on front wheels through the drive
train.
______________________
82
the brake pedal
The brake pedal applies the rear brake
only. Should the front brakes system
fail, the rear brake can be activated by
depressing the brake pedal.
vmo2008-016-003_a
1. Brake pedal

14) Footpeg

Use this area to keep your feet and the
passenger's feet stable.
vmo2008-016-004_a
1. Operator's footpeg
2. Passenger's footpeg

15) Grab Handles

The grab handles must be used by the
passenger to hold on firmly during ve-
hicle operation.
WARNING
Never hold on to the operator. Al-
ways hold the grab handles firmly.