How Ip Address Changes Affect Unit Control - AMX NMX-ENC-N1122 Instruction Manual

Changing Stream Setting
FIG. 15
7. Repeat these steps until all Encoders are connected to the network and configured with an appropriate Stream number.
NOTE: Each Encoder's Stream number must be unique to all other Encoders on the network.
NOTE: Screen-by-screen descriptions of the web interface options are provided for your reference in the
Options section on page 25
Step 4. Conf iguring Decoder and Encoder IP addresses (if needed)
By default, all Decoders and Encoders are preset to Auto IP mode. This means that the IP address is pre-configured to
169.254.xxx.xxx with a subnet mask of 255.255.0.0. When an N1000 is first connected to the network, Auto IP checks the network
for available IP addresses in the 169.254.xxx.xxx range and then makes an appropriate, static assignment to each unit. It may be
beneficial in some applications to use DHCP (Dynamic Host Control Protocol) or static IP addresses, but IP configuration changes
must be done correctly to avoid any communication disruptions with the N1000 unit.

How IP Address Changes Affect Unit Control

As discussed previously, N-Able control is dependent upon the host computer being in the same IP address range as the SVSI
devices. Therefore, before making any N1000 IP address changes, we recommend having two statically-assigned IP addresses on
your computer.
Configure the first IP address to be in the range of the default N-Series IP settings (i.e., in the 169.254.xxx.xxx range), AND

Configure a second IP address in the range of the IP address you are planning to assign to the units (or when using DHCP,

an address within the defined range for your network).
N1000 Series User Manual
and the Decoder Conf iguration Options section on page
Installing and Configuring Your AV Equipment
Encoder Conf iguration
41.
18