AMX NMX-ENC-N1122 Instruction Manual page 9

Front and Rear Panel Descriptions
Front Panel
USB Mini-B port
USB Standard-A port (x2)
RESET button
ID button
POWER LED
STATUS LED
Rear Panel
+12V 2A
PWR LED
HDMI LED
STAT LED
STRM LED
P0 POE
P1
IR
RS232
AUDIO
HDMI IN
HDMI OUT
VGA IN
N1000 Series User Manual
Connects the Encoder to the computer to be controlled (N1133 only).
Connects the Decoder to keyboard and/or mouse or touchscreen (N1233 only).
Recessed pushbutton. Press to initiate a "warm restart" which causes the processor to reset, but not lose
power. A reset does NOT affect the current settings.
Recessed pushbutton. Press to send notification out on the network to identify the unit (the notification
causes a pop-up dialog in N-Able). Press and hold for 30 seconds to initiate a factory restore. N-Able
must be set to Force UDP Server Bind to port 50005 for this to work.
On solid (green) when operating power is supplied (via PoE or local power supply). This activity is also
shown by the PWR LED on the rear panel.
On flashing (green) when there is software activity. This activity is also shown by the STAT LED on the rear
panel.
12 Volt DC power input.
Same as POWER LED described above.
On (green) when an HDMI connection exists.
Same as STATUS LED described above.
On (green) when the unit is streaming video.
8-wire RJ45 female.
10/100/1000 Mbps 10/100/1000Base-T auto-sensing gigabit Ethernet switch port.
Provides both the network connection and the power to the Encoders and Decoders.
8-wire RJ45 female.
10/100/1000 Mbps 10/100/1000Base-T auto-sensing gigabit Ethernet switch port.
OR
1G SFP port which accepts compatible fiber transceivers or direct attach cables (copper or fiber).
Modules sold separately.
Note: SFP support is model-dependent. Depending on the model, the P1 port is either an SFP (N1133/
N1233) or an RJ45 (N1122/N1222) network connection.
2-pin terminal Phoenix connector. Provides IR output only (33 to 60 kHz). An emitter may be necessary
(not included).
3-pin terminal Phoenix connector which provides a serial control interface. Full duplex communication.
Available terminal speed settings: 1200 to 115200 baud rate.
5-pin terminal Phoenix connector which provides user-selectable balanced/unbalanced, dedicated audio
input (for Encoders) and output (for Decoders).
HDMI video input (Encoders).
HDMI video output (Decoders).
DB-15 analog input. Allows for the use of analog video sources (Encoders).
Introducing Your New N1000 Series
9