AMX NMX-ENC-N1122 Instruction Manual page 15

5. Enable the Use the following IP
address option, and enter the
static IP address provided to you
by your network administrator.
NOTE: If the computer does not need Internet access, you can simply enter a unique 169.254.xxx.xxx IP address with a 255.255.0.0
subnet mask. Contact your network administrator if you are unsure of how to conf igure the existing network. SVSI units will not self-
assign in the 169.254.0.xxx range.
NOTE: If the computer has a statically-assigned IP address, click the Advanced button. Then click Add to enter a unique
169.254.xxx.xxx address with a Subnet Mask of 255.255.0.0 and a Default Gateway of 169.254.1.1.
Step 2. Connecting Decoders to the Network
The digital connection from a Decoder HDMI OUT port (female) to a display is accomplished using either a HDMI cable or DVI-D
(through adapter). N1000 units support embedded audio input and output on the HDMI ports; however, some display devices (e.g.,
many monitors) do not support embedded audio. When using such a display, use the AUDIO port for separate transmission of
sound and turn HDMI Audio off (on the Settings page) to avoid video display issues.
Power is supplied via a PoE-enabled switch or an external power supply. Refer to the following steps and
1. Using a Cat-5 cable, connect your SVSI Decoder's P0 port to a PoE-enabled switch. This provides both network and power
connection. In non-PoE applications connect a 12V regulated power supply (N9312) to the two-pin terminal block plug
connector (labeled +12V 2A).
2. Connect the display you would like to use for that Decoder (monitor, projector, etc.) to the Decoder's HDMI OUT port using an
HDMI cable (or DVI through adapter). This must be a digital video connection.
Decoder Connections
FIG. 11
3. Repeat Steps 1 and 2 until all Decoders are installed on the network.
N1000 Series User Manual
N1000 Decoder
Cat-5 Cable
PoE-Enabled Switch
Installing and Configuring Your AV Equipment
HDMI Cable
Figure 11 for guidance.
Network
15