Status Section - AMX NMX-ENC-N1122 Instruction Manual

Status Section

The Status section of the Settings page is shown in
Status Section
FIG. 45
Settings Page: Status Section
TABLE 17
Option
HDMI Status
Input Resolution
Port 50001 Source IP
Port 50002 Source IP
Serial Source IP
Flush buttons
KVM IP
N1000 Series User Manual
Figure
Description
Indicates if video is connected to the Decoder.
Indicates the video resolution of the incoming video
source.
Shows the IP address of the currently connected device
or displays Disconnected if no connection exists.
Shows the IP address of the currently connected device
or displays Disconnected if no connection exists.
Shows the IP address of the currently connected device
or displays Disconnected if no connection exists.
These buttons reset the port.
Shows the IP address of the KVM Encoder currently
connected to this Decoder.
45. Options are described in Table
Notes
Port 50001 can only accept a single external
connection at a time. If a device is currently showing
the port occupied (by a control system or other
device), then other connections will be rejected.
However, connection attempts from the same IP will
override the current connection.
Port 50002 can only accept a single external
connection at a time. If a device is currently showing
the port occupied (by a control system or other
device), then other connections will be rejected.
However, connection attempts from the same IP will
override the current connection.
Only a single external connection can be accepted on
the port. If a device is currently showing the port
occupied (by a control system or other device), then
other connections will be rejected. However,
connection attempts from the same IP will override
the current connection.
This setting only applies to the N1233.
Decoder Configuration Options
17.
48