Meyer Sound RMServer Hardware Manual page 44

CHAPTER 7: MX RMS MODULE
4. Lift out the user panel.
NOTE: Make sure to hold the MX RMS module
by its edges. Avoid touching any of the compo-
nents on the module.
5. Disconnect the ribbon cable from the interconnect Input/
RMS module.
Disconnect the
ribbon cable from
the user panel
6. The main RMS PCBA module is attached to the amplifier
chassis, as can be seen in this top view.
44
Lift the
user panel
7. Unplug the user panel from the primary AC mains PCMA
board.
Lift to disconnect user panel
from AC mains power
8. Disconnect the ribbon cable from the control card.
Disconnect the ribbon cable
from the control card
9. Remove the ribbon cable from the main PCBA board by
releasing the latches on both sides of the connector.
Release the latches locking
down the ribbon cable
Disconnect the
power harness