Installing The Mute Jumper On The Ultraseries Rms Module - Meyer Sound RMServer Hardware Manual

CHAPTER 5: ULTRASERIES RMS MODULE
To install the UltraSeries RMS module:
1. Remove the loudspeaker's AC power cable and audio
cable and place the loudspeaker on a clean, low-static
flat surface. Orient the loudspeaker with the top facing
up. Wait at least five minutes before removing the Ultra-
Series RMS module.
2. Remove the four screws securing the cover plate for the
slot below the audio input module. Save the cover plate
in case you need it in the future.
3. Verify that the copper strip on the left side of the open
slot is not damaged and properly positioned. The copper
strip helps ground the UltraSeries RMS module to the
chassis. If you need to replace the copper strip, contact
Meyer Sound.
Copper strip
38
4. Locate the ribbon cable beneath the audio input module
and attach this cable to the rear connector on the Ultra-
Series RMS module. Make sure to fully lock the connec-
tor.
Locking
connector
5. Slide the UltraSeries RMS module into the open slot
(below the audio input module) and secure it with the
four screws.
6. Reconnect the loudspeaker's AC power cable and audio
cable and apply power to the loudspeaker. The Activity
LED blinks to indicate the UltraSeries RMS module is
operational and ready to be discovered on the network.
INSTALLING THE MUTE JUMPER ON THE
ULTRASERIES RMS MODULE
To use the mute and solo functions of the UltraSeries RMS
module, the Mute Jumper must be installed on the module.
Meyer Sound currently ships RMS-equipped loudspeakers
with the Mute Jumper installed. These mute-enabled loud-
speakers can be identified by the blue "ME" sticker on the
UltraSeries RMS user panel. Older RMS-equipped loud-
speakers can be easily mute-enabled by installing the Mute
Jumper, available from Meyer Sound in a mute jumper kit, P/
N 476.005 RMS Mute Enable Replacement Upgrade
Jumper.
CAUTION: Do not mistakenly install the Mute
Jumper on the white, unlabeled two-pin con-
nector on the UltraSeries RMS module. This connec-
tor is for the VEAM connector option; using it for any
other purpose will damage the module.