Meyer Sound RMServer Hardware Manual page 16

CHAPTER 2: INSTALLING AND CONFIGURING RMSERVER
Date and Time Settings Dialog
Figure 10: Date, time, and time zone are set in the Date and Time
Settings dialog.
Date: To change the date, click in the field and use the cal-
endar that drops down to set the date.
Time: To change the time, click in the field and choose the
desired time from the list that drops down.
Time Zone: To change the time zone, click in the field and
choose your time zone from the list that drops down.
Click the Save button in the lower right to save the settings.
The Cancel button in the lower left exits the dialog without
saving changes. A close box for the dialog is in the upper
left corner.
Email Notification**
Status:
(Not Configured)
Setup button: Click to open the Edit Email Configuration dia-
log.
Edit Email Notification Dialog**
Send To: Enter the email address to which you want email
alerts sent. Multiple email addresses can be entered, sepa-
rated by commas.
Events (checkboxes): These checkboxes indicate the events
whose occurrence triggers an email alert.
When external muting is triggered
When external relays are triggered
Intervals: Limits the frequency with which alarm signals are
sent.
Alarms no more than once per every (drop down w/times 15
s – 24 h)
SMTP Configuration: In order to send email notifications,
RMServer must be configured to communicate with an
SMTP server than can send mail. These are the same
parameters required to set up an email client on your com-
puter, though the values you enter here may or may not be
the same as for your personal email.
16
SMTP Server: The URL of the outgoing mail server.
[33]
Port:
The section of three security settings is enabled by the
checkbox at its top.
SMTP Server Requires Authentication checkbox: Enables
security settings.
Encryption Type: To set the encryption type, click in the field
and choose the desired encrypition from the menu that
drops down.
Username: Enter the username on the account you are log-
ging into.
Password: Enter the username on the account you are log-
ging into.
The Send Test Email button at the bottom of the dialog
sends a message to the email address specified in the Send
To: field, so that successful address of the email path is con-
firmed.
Click the Save button in the lower right to save the settings.
The Cancel button in the lower left exits the dialog without
saving changes. A close box for the dialog is in the upper
left corner.
TIP: For more information on using the Opto
Inputs and Relay Outputs, see Appendix C,
"External Muting and External Warning Relays."
Opto Inputs 1 and 2**
If either or both enabled opto inputs are triggered, all loud-
speakers with mute jumpers configured will be muted.
Checkboxes:
Enable External Muting on opto input 1
Enable External Muting on opto input 2
The Save button applies any changes made in this section
and saves the settings to RMServer.
Relay Configuration**
Relay 1 Displays current settings for relay 1.
(Set to trigger on (Speaker Offline) (Load Fault))
Relay 2 Displays current settings for relay 1.
(Set to trigger on (Speaker Offline) (Load Fault))
Setup button: Opens the Edit Relay Setup dialog, where
relay behavior is specified.