Table of Contents
Advertisement
CHAPTER 4: HP/MP RMS MODULE
CAUTION:
Do not mistakenly install the Mute
Jumper on the white, unlabeled two-pin con-
nector on the HP/MP RMS module. This connector is
for the VEAM connector option; using it for any other
purpose will damage the module.
3. Reinstall the HP/MP RMS module in the loudspeaker.
HP/MP RMS USER PANEL
The HP/MP RMS user panel has three LEDs, two buttons,
and two Network connectors.
Figure 8: HP/MP RMS Module
NOTE:
The buttons and LED on the HP/MP
RMS user panel are used exclusively by Com-
pass RMS and have no effect on the acoustical or
electrical activity of the loudspeaker.
Service LED (Red)
The red Service LED provides the following feedback:
■
When unlit, the loudspeaker is successfully connected to
the network and discovered.
■
When blinking once every two seconds, the loudspeaker
is connected to the network but not yet discovered in
Compass.
When lit continuously, the loudspeaker's RMS hardware
■
has failed and may indicate that the module has been
damaged (contact Meyer Sound Technical Support).
Service Button
Pressing the Service button identifies the loudspeaker in the
Compass RMS system and notifies Compass that the loud-
speaker is connected. You can simultaneously press the
Reset and Service buttons to reset the HP/MP RMS module,
undiscover the loudspeaker, and remove it from the
RMServer inventory (see "Resetting the HP/MP RMS Mod-
ule" on page 35).
34
Wink LED (Green)
The green Wink LED lights when a signal is sent from Com-
pass by clicking the Wink button on a loudspeaker object in
meter view on a user page. This is useful for identifying the
physical loudspeaker corresponding to a loudspeaker icon
in Compass.
Reset Button
Pressing the Reset button causes the HP/MP RMS module's
firmware to reboot; this will not affect whether the loud-
speaker is discovered (which is stored in flash memory). You
can simultaneously press the Reset and Service buttons to
reset the HP/MP RMS module, undiscover the loudspeaker,
and remove it from the RMServer inventory (see "Resetting
the HP/MP RMS Module" on page 35).
Activity LED (Green)
The green Activity LED flashes continuously when the loud-
speaker has been successfully discovered.
RMS Network Connectors
The two Weidmuller connectors transfer data to and from
the RMS network. Two connectors are provided to allow for
easy connection of multiple (daisy-chained) loudspeakers
on the network. Included with each RMS-equipped loud-
speaker are RMS cable connectors and mounting blocks for
constructing RMS cables. The RMS blocks allow the cables
to be securely attached to the RMS module with screws.
NEURON ID FOR HP/MP RMS MODULES
Each HP/MP RMS module has a unique 12-character Neu-
ron ID (NID) that identifies the loudspeaker on the network.
The NID should be discovered automatically by the
RMServer to which it is connected, but can be entered man-
ually, if necessary. The NID for the HP/MP RMS module is
located on the user panel below the orange RMS Network
connectors (see Figure 8 on page 34).
Hide quick links:
Advertisement
Table of Contents
