Neuron Id For Ultraseries Rms Modules; Resetting The Ultraseries Rms Module - Meyer Sound RMServer Hardware Manual

CHAPTER 5: ULTRASERIES RMS MODULE
Wink LED (Green)
The green Wink LED lights when a signal is sent from Com-
pass by clicking the Wink button on a loudspeaker object in
meter view on a user page. This is useful for identifying the
physical loudspeaker corresponding to a loudspeaker icon
in Compass.
Reset Button
Pressing the Reset button causes the UltraSeries RMS
module's firmware to reboot; this will not affect whether the
loudspeaker is discovered (which is stored in flash memory).
You can simultaneously press the Reset and Service buttons
to reset the UltraSeries RMS module, undiscover the loud-
speaker, and remove it from the RMServer inventory (see
"Resetting the UltraSeries RMS Module" on page 40).
Activity LED (Green)
The green Activity LED flashes continuously when the loud-
speaker has been successfully discovered
RMS Network Connectors
The two Weidmuller connectors transfer data to and from
the RMS network. Two connectors are provided to allow for
easy connection of multiple (daisy-chained) loudspeakers
on the network. Included with each RMS-equipped loud-
speaker are RMS cable connectors and mounting blocks for
constructing RMS cables. The RMS blocks allow the cables
to be securely attached to the RMS module with screws.
NEURON ID FOR ULTRASERIES RMS
MODULES
Each UltraSeries RMS module has a unique 12-character
Neuron ID (NID) that identifies the loudspeaker on the net-
work. The NID should be discovered automatically by the
RMServer to which it is connected, but can be entered man-
ually, if necessary. The NID for the UltraSeries RMS module
is located on the user panel below the orange RMS Network
connectors (see Figure 9 on page 39 and Figure 10 on
page 39).
40
RESETTING THE ULTRASERIES RMS
MODULE
You can use the Reset and Service buttons to reset the
UltraSeries RMS module, which will cause the module to be
reset, and loudspeaker to be undiscovered and removed
from the RMServer inventory.
To reset the UltraSeries RMS module:
1. Press and hold the Service button for 10 seconds.
2. While continuing to hold down the Service button, press
and hold the Reset button for 5 seconds.
3. After releasing the Reset button, continue holding down
the Service button for 5 seconds. The UltraSeries RMS
module is reset and the loudspeaker is undiscovered and
removed from the RMServer inventory. The UltraSeries
RMS module's red Service LED blinks.